Swivel-mounted stationary edging. The CONTURO is also suitable for working when stationary. To this end, it is easily introduced into the MFT/3 Conturo-AP multifunction table. Not only can you affix edging to straight edges or curves, but also to oblique edges with an angle between 90° and 45° because the CONTURO can be tilted 90°–45° in the stationary unit. For mounting the edge bander on a workbench|Continuously adjustable angle of 0–47°|Allows the user to swivel the machine (0 – 47°) in the bench and position the workpiece horizontally during edging - for convenient and safe guidance, even with larger objects|Supplied sliding guides for guiding the workpiece safely|Perfect edging overhang when using the supplied sliding guides|Quick to install and remove the edge bander without tools|Secure fixing of the machine with slide lock|Additional roller as expansion of the pressure zone or for edging of complex shapes|Adjustable guide rail adapter for exactly parallel feeding in of the panel when edging mitres, therefore the edge doesn't run off course|Deflector that keeps the introduced edge away from the workpiece area|Start button of the machine always ideally reachable. For small batches, straight edges, free form elements and gluing inclined edges, angle from 0-47°. The CONTURO as a stationary machine|Attaching edging to straight or shaped parts|Attaching edging to mitre joints|Simple MFT 3 conversion. To work with the CONTURO as a stationary unit, simply insert the machine in an adapter plate in the MFT 3 multifunction table or a bench you have built yourself. Not only can you affix edging to straight edges or curves, but also oblique edges with an angle between 90° - 45° because the CONTURO can be tilted 90° - 45° in the stationary unit.|This stationary working method is very practical for straight edges along small or narrow workpieces that are difficult to clamp. The edge is inserted in the usual way, the workpiece is then guided along the rail while even pressure is applied to the contact roller.|For attaching edging to mitre joints, the CONTURO is simply tilted in the stationary unit to the desired angle (angles of 90° - 45° are possible). The guide rail adapter ensures that the edge is glued on straight and does not run off course. The rail can be set for edge thicknesses of 0.5 - 3 mm. The workpiece is then simply guided past the CONTURO and the edging is glued on.|Any conventional MFT 3 multifunction table can also be easily converted for stationary use of the edge bander. The standard perforated top on the MFT 3 can be easily replaced with the special LP-KA65 MFT/3 perforated top – the required M4 sleeves for screwing in the guide plates are included. The AP-KA 65 adapter plate is also required – 15 guide plates are included. table with perforated top and foldaway legs|for using the edge bander CONTURO KA 65 as a bench-mounted machine. for KA 65
